ZI

InitZero

ZI

Command Group: Calibration	Access:	Network interfaces:
TAC protected	RW	CANopen	SDO2300sub10
		MODbus	221E,2
ZI - Init Zero Range.		PROFIbus	read 3,16 write 4,16

Synopsis:
	Command	Response
Get	ZI	R<Value>
Set	ZI <Value>	OK (or ERR)

Valid for	Min. value	Max. value
151.181	0	999999
152.181	0	999999
162.181	0	999999
179.181	0	999999
181.181	0	999999
64.181	0	999999
64.184	0	999999
68.181	0	99999
69.181	0	999999
78.183	0	99999

ZI Defines the first set zero. If ZI is non-zero the device will perform an automatic Set-Zero when the weight stabilizes with the No-motion settings and the weight is within the ZI range.