PL3

Flow dTime

PL3

Command Group: MassFlow	Access:	Network interfaces:
	RW	CANopen	SDO2B00sub03
		MODbus	2504,2
PL3 - Set the flow measure timeslot length		PROFIbus	read 42,3 write 42,131

Synopsis:
	Command	Response
Get	PL3	P3:<Value>
Set	PL3 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.185	0	999999
142.185	0	999999
143.185	0	999999
88.185	0	262143

PL3 Delta Time

This command defines the time base (Δt) for all loss in weight / mass flow rate calculations. Δt is setup in increments of 10ms i.e. a value of 100 result in a Δt of one second.

Remark: A long delta time leads to greater accuracy but with a slower update rate. A short delta time leads to the opposite.

See also LS, LI, GF, GR, GM, PL1, PL2, PL4, PL5.
And for the DAD: VF, GD, PL6, PL7, PL8, PL9, PL10, PL11, PL12, PL13, PL14, PL15, PL16, PL17, PL18, PL19, PL20, PL21.