PL2

Flow Scale

PL2

Command Group: MassFlow	Access:	Network interfaces:
	RW	CANopen	SDO2B00sub02
		MODbus	2502,2
PL2 - Set the flow scale		PROFIbus	read 42,2 write 42,130

Synopsis:
	Command	Response
Get	PL2	P2:<Value>
Set	PL2 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.185	0	8
142.185	0	8
143.185	0	8
88.185	0	8

PL2 Flow Time Scale

Select Loss-In-Weight / Mass Flow rate (weight unit / time unit).
The following rates units are available:

0: Kg/sec.
1: Kg/min.
2: Kg/hour
3: 1000 Kg/sec. (t/sec.)
4: 1000 Kg/min. (t/min.)
5: 1000 Kg/hour (t/hour)
6: 1000 t/sec.
7: 1000 t/min.
8: 1000 t/hour

For the DAD141/DAD142 using Firmware 1.60 and later, this command defines the time scaling of the weight / mass flow rate, which means delta weight per time unit.
The following scalings are available:

0: Units/sec. (K = 100)
1: Units/min. (K = 6000)
2: Units/hour. (K = 360000)

See also LS, LI, GF, GR, GM, PL1, PL3, PL4, PL5.
And for the DAD: VF, GD, PL6, PL7, PL8, PL9, PL10, PL11, PL12, PL13, PL14, PL15, PL16, PL17, PL18, PL19, PL20, PL21.