PL1

Flow DP

PL1

Command Group: MassFlow	Access:	Network interfaces:
	RW	CANopen	SDO2B00sub01
		MODbus	2500,2
PL1 - Flow decimal point		PROFIbus	read 42,1 write 42,129

Synopsis:
	Command	Response
Get	PL1	P1:<Value>
Set	PL1 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.185	0	5
142.185	0	5
143.185	0	5
88.185	0	5

PL1 Decimal point position.

This command defines the position of the decimal point for loss in weight / mass flow scaling. This decimal point setting is only used for the Mass Flow (GF) value.

See also LS, LI, GF, GR, GM, PL2, PL3, PL4, PL5.
And for the DAD: VF, GD, PL6, PL7, PL8, PL9, PL10, PL11, PL12, PL13, PL14, PL15, PL16, PL17, PL18, PL19, PL20, PL21.