PL18

Fault_Status

PL18

Command Group: MassFlow	Access:	Network interfaces:
	RW	CANopen	SDO2B00sub12
		MODbus	2522,2
PL18 - Fault Status		PROFIbus	read 42,18 write 42,146

Synopsis:
	Command	Response
Get	PL18	P18:<Value>
Set	PL18 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.185
142.185
143.185

PL18 Fault status

This parameter hold the actual fault status.
Any combination of these faults can be programmed to give an alarm and stop the dosing process - see PL17.

Available setup flags range: 0 to 255.

1 = Error 4 + 5 (Load cell connection)
2 = Mass flow not OK
4 = Mass flow tolerance
8 = Refill fault (Weight, time)
16 = Frozen period too long
32 = Hopper Overload
64 = Not used – always at zero
128 = Not used – always at zero

The Fault statis flags can be cleared by writing a 0 (zero) to PL18

See also LS, LI, GF, GR, GM, PL1, PL2, PL3, PL4, PL5.
And for the DAD: VF, GD, PL6, PL7, PL8, PL9, PL10, PL11, PL12, PL13, PL14, PL15, PL16, PL17, PL19, PL20, PL21, and AA