PL10

Flow Tolerance

PL10

Command Group: MassFlow	Access:	Network interfaces:
	RW	CANopen	SDO2B00sub0A
		MODbus	2512,2
PL10 - FlowTolerance		PROFIbus	read 42,10 write 42,138

Synopsis:
	Command	Response
Get	PL10	P10:<Value>
Set	PL10 <Value>	OK (or ERR)

Valid for	Min. value	Max. value
141.185	0	100
142.185	0	100
143.185	0	100

PL10 Mass flow tolerance band

This command sets a tolerance band to e.g. ± 20% of the current mass flow.
As soon as the tolerance band is exceeded, a corresponding error message appears.

Setup range: 0 … 100 %. (100% = not active, 0% permanent active)

See also LS, LI, GF, GR, GM, PL1, PL2, PL3, PL4, PL5.
And for the DAD: VF, GD, PL6, PL7, PL8, PL9, PL11, PL12, PL13, PL14, PL15, PL16, PL17, PL18, PL19, PL20, PL21, and AA