CV |
Value for Absolute Calibration |
CV |
Command Group: Calibration | Access: | Network interfaces: | ||
| TAC protected | RW | CANopen | SDO2300sub18 | |
| MODbus | 222E,2 | |||
CV - Value for Absolute Calibration | PROFIbus | read 3,24 write 4,24 | ||
|
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||
CV Value for Absolute Calibration.
This value is used when calibration with absolute values are performed over a network.
The AG command has two parameters in ASCII mode, but only one when using CanOpen, MODbus, or ProfiBus.
Therefore the second parameter for the AG command is taken from this this register, when calibration is done over the network.
Note that LDM88 uses the CG value for this, and the mvV/V must be adjusted accordingly.